Power & Source of Big Ideas

Boot from eMMC M4 v2

Moderators: chensy, FATechsupport

Hi all, I am trying to boot my M4 v2 from the eMMC card without success. It boots perfectly from the sd card but ends up at a initramfs shell when trying to boot from the eMMC card. I think it is looking for /dev/mmcblk0 which I believe is the sdcard - any ideas how I can get around this ?
I am no expert for NanoPI.
But in general LSBLK helps, as it lists all available block devices.

If you cannot execute it from initramfs just issue it when you booted from SD. eMMC must be attached though, else it won't be shown.

Since MMC and SD are dealt with similar by udev, it probably is /dev/mmcblk1?

The problem might be located somewhere else. In this case I cannot help, since I don't have a NanoPI (yet).

Who is online

In total there are 8 users online :: 1 registered, 0 hidden and 7 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: legrande82 and 7 guests