Power & Source of Big Ideas

Configuration of R2S as Router+

Moderators: chensy, FATechsupport

I don't quite understand what I'm missing here. I have lots of experience with modded router firmware, openwrt, tomato, ect.

I am trying to use a nano r2s as router/gateway for my asus ac86r (running fresh tomato)

but when I try and just setup the r2s openwrt as is, or customize routes and ips, I cannot seem to get it to work as WAN dhcp dns like my router does, and move my router over to wap/switch and disable my own wan functions (bridge port to lan)

I am unsure what I am missing, you would think the software should out of the box work as gateway right? with dhcp wan and static lan? what am I missing?

I'd like to install these in front of a few networks and run ddns and other services to coordinate several remote sites passive data.
any more details about your specific config?

Who is online

In total there is 1 user online :: 0 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 1 guest