Power & Source of Big Ideas

NanoPi M4V2 heat sink mounting holes

Moderators: chensy, FATechsupport


I'm putting together a NanoPi M4V2 based NAS and would like to check case options.
Does anybody know (or can anybody measure) the dimensions of the mounting holes on the M4V2 heat sink? Any chance some of the 6 holes on the top of the heat sink match mounting holes on 2.5 inch hdds /ssds?


those 6 holes are 40mm apart on the long side (3 of them) and 50mm apart on the short side (2 of them)

they don't line up with ssd drives.

I'd look into using the 1/4" 'camera' mounts for any custom rig, these are versatile due to the wide range of camera equipment that use this type of mount.

good luck.

Who is online

In total there are 8 users online :: 0 registered, 0 hidden and 8 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 8 guests