Power & Source of Big Ideas

T4: HDMI Codec and Multichannel

Moderators: chensy, FATechsupport

Hi there.

Whatever I do, the HDMI-CODEC audio device in ALSA is showing ONLY as stereo. As I can understand the TRM, the HDMI is attached to I2S2 (ff8a0000), which must be multichannel.
Trying to understand the kernel driver, I found out that channels_max is proper 8, not 2.
Where's the problem? There's no default asound.conf in the distro, so ALSA must find out the number of channels automatically, however plugging a receiver to the T4 results only in "failed to get edid" (as there is no TV attached) and "asoc-simple-card hdmi-codec: i2s-hifi <-> ff8a0000.i2s mapping ok". The receiver shows only Left and Right channels, too...

What am I doing wrong? I need all 8 channels through HDMI.
I'll poke the topic.
Having fixed the dts, I could say "aplay -c 8", and /proc/asound/card2 does show channels: 8 on playback.
But the HDMI device does NOT recognize 8 streams in any way.

Am i stupid, or is there any additional wiring config for sending 8-channel audio to hdmi?!

Thank you.

Who is online

In total there are 6 users online :: 0 registered, 0 hidden and 6 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 6 guests