Power & Source of Big Ideas

Power On Mode Select Jumper

Moderators: chensy, FATechsupport

Can't find info on this in the wiki - which jumper position does what? Thanks.
Looks like it comes from factory set to boot on return of power after a cut...
crsp wrote:
Looks like it comes from factory set to boot on return of power after a cut...


Yip. My T4 boots on applying power so looks like FA set this as the default on later boards. For boards without this, the following needs to be done.

Only need to solder in 2 parts, resistor and capacitor.

http://wiki.friendlyarm.com/wiki/index. ... y_T4_PWRON

Who is online

In total there are 3 users online :: 0 registered, 0 hidden and 3 guests (based on users active over the past 5 minutes)
Most users ever online was 2865 on Sun Nov 10, 2019 5:27 am

Users browsing this forum: No registered users and 3 guests