Power & Source of Big Ideas

Power Input : 5V/3A, via GPIO1 on M4

Moderators: chensy, FATechsupport

the wiki mentions that it is possible to power the NanoPi M4 via the Notes
"Power Input : 5V/3A, via USB Type-C(USB PD Specification is not supported) or Pin2&Pin4 of the 40-pin GPIO1 header"

any one knows anything more about this ??? its kinda vage what pins to use , im gessing its any of them for the 5 v imput and then one of the gnd for the gnd???
I am powering the T4 from the GPIO too and use both pins to ensure the current is sufficient. Also makde sure ALL gnd connections are used.

Who is online

In total there are 3 users online :: 0 registered, 0 hidden and 3 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 3 guests