Power & Source of Big Ideas

Casing or Housing for M4 with heatsink

Moderators: chensy, FATechsupport

Hi,

Do you have casing or housing for M4 with heatsink?
Or are there compatible case for M4 with heatsink?

Thank you

KR
I have the same with acrylic case preference. Any pointer?
Hi there
I found and printed this one: https://www.thingiverse.com/thing:3313324
Nice and fitted perfectly
I found the top really flimsy but does the job ok...
I'm using the official RPI case. i used an exacto knife to cut out the bottom, soft plastic made it easy. the usbc hole needed to be enlarged a bit but no big deal. Remembet to cut off the fin between the usb ports to leave room for the uart. I chose this mainly for the fact that the top and side plates are easily removable and could be swapped for custom 3d parts eventually.
Image

Who is online

In total there are 7 users online :: 0 registered, 0 hidden and 7 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 7 guests