Power & Source of Big Ideas

Unable to Create Bootable Kernel

Moderators: chensy, FATechsupport


I followed the instructions at http://nanopi.org/nanopi_development.html. However, the produced kernel does not boot. There is simply no output after u-boot runs. I copied arch/arm/boot/zImage to the first partition of the SD card. There is no resource I could find to generate a new dtb for the new kernel.

I also tried the mainline kernel, the Xenial kernel, and a kernel from a linux-sunxi developer.

I can produce modules which successfully load.

Thanks in advance,
The kernel and instructions you referred on the link are not for H2+.

Linux kernel source tree for FriendlyARM NanoPi (s3c2451)

Who is online

In total there are 3 users online :: 0 registered, 0 hidden and 3 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 3 guests