Power & Source of Big Ideas

Output nanopi neo2 via HDMI

Moderators: chensy, FATechsupport

I see there is a way to buy a separate board called TTL To RS232 Module PSU-ONECOM that has VGA (RS232) on it, but I was wondering how to connect nanopi neo2 via HDMI to my monitor? Right now I can connect via serial bus using USB2UART and software Putty, but I'd much rather prefer to have the desktop output (GUI) of the Ubuntu 16 that's installed in nano pi neo2.
Also, this TTL To RS232 Module, how does one connect mouse and keyboard to neo2 computer? To one of the other pins?
DB9.jpg
DB9.jpg (22.96 KiB) Viewed 1407 times

The blue connector isnt VGA. Its a DB9 serial-RS232 connector.
The NanoPi Neo2 hasnt Video-Out - so you cant connect VGA or HDMI.

The NanoPi Neo2 is build to use it headless (without a monitor) and only remote or via the serial Debug-Port.

Who is online

In total there are 9 users online :: 0 registered, 0 hidden and 9 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 9 guests