Power & Source of Big Ideas

one wire pin assignment on the nanopi2

Moderators: chensy, FATechsupport

After looking at the matrix library code for the nanopi2, I discovered that the library supports the one-wire ds18b20 temperature sensor. However there's no indication as to which pin is the w1-gpio driver attached to. Can somepne please confirm that pin to which the one wire driver is attached to? Also will i need to add an external pull-up resistor? or is the pull-up internally enabled.

Thank you.
Hi thank you very much for paying attention to our matrix.

You can check our wiki for the temperature module:
http://wiki.friendlyarm.com/wiki/index. ... ure_Sensor

It has detailed information on how to use it. I wish this could help you

Who is online

In total there are 3 users online :: 0 registered, 0 hidden and 3 guests (based on users active over the past 5 minutes)
Most users ever online was 2865 on Sun Nov 10, 2019 5:27 am

Users browsing this forum: No registered users and 3 guests