Power & Source of Big Ideas

nanopi M1 and waveshare 10.1inch HDMI LCD 1024×600

Moderators: chensy, FATechsupport

Hello
I got the win nanopi M1 and 10.1inch HDMI LCD
http://www.waveshare.com/wiki/10.1inch_HDMI_LCD

I have tried running debian and armbian
LCD effort to win the overall picture, and now I've Contact
But the main problem I use this LCD is touch and connected to SPI
The board of chip is used XPT2046

Would you please advise
Hi
You can refer to our SPI wiki tutorial:http://wiki.friendlyarm.com/wiki/index.php/Matrix_-_2%278_SPI_Key_TFT

Thanks!
chensy wrote:
Hi
You can refer to our SPI wiki tutorial:http://wiki.friendlyarm.com/wiki/index.php/Matrix_-_2%278_SPI_Key_TFT

Thanks!


Thank you very much for your answer
I've already done it, but failed

Difficulty moving the pin T_IRQ and LCD_D / C in the LCD's
I armbian operating system installed.
And I can not find the file xorg.conf in the x11 folder
polestar wrote:
chensy wrote:
Hi
You can refer to our SPI wiki tutorial:http://wiki.friendlyarm.com/wiki/index.php/Matrix_-_2%278_SPI_Key_TFT

Thanks!


Thank you very much for your answer
I've already done it, but failed

Difficulty moving the pin T_IRQ and LCD_D / C in the LCD's
I armbian operating system installed.
And I can not find the file xorg.conf in the x11 folder


Hi
SPI lcd only can work with debian and ubuntu systerm.

Thanks!

Who is online

In total there are 28 users online :: 0 registered, 0 hidden and 28 guests (based on users active over the past 5 minutes)
Most users ever online was 576 on Tue Aug 20, 2019 5:38 pm

Users browsing this forum: No registered users and 28 guests