Power & Source of Big Ideas

Replece H3 BGA

Moderators: chensy, FATechsupport

H3 burned out!
Hello I'm having a problem on a nanoPi -M1 card
This board is with H3 damaged, would you like to know the following?
If I replace the H3 alwinner with a new H3 BGA, purchased directly from an Alwinner vendor, would it be necessary to have some firmware for this new processor to work on the nanoPi-M1 card?
Or would simple replacement suffice to function?
Can you answer me, please? I will be grateful!

Sorry in English because it is not my native language.

Thank you!
joctal wrote:
H3 burned out!
Hello I'm having a problem on a nanoPi -M1 card
This board is with H3 damaged, would you like to know the following?
If I replace the H3 alwinner with a new H3 BGA, purchased directly from an Alwinner vendor, would it be necessary to have some firmware for this new processor to work on the nanoPi-M1 card?
Or would simple replacement suffice to function?
Can you answer me, please? I will be grateful!

Sorry in English because it is not my native language.

Thank you!



Hi,

You can replace it with a new H3 chip, no firmware inside it.


Good luck

-- Mindee

Who is online

In total there are 27 users online :: 0 registered, 0 hidden and 27 guests (based on users active over the past 5 minutes)
Most users ever online was 2865 on Sun Nov 10, 2019 5:27 am

Users browsing this forum: No registered users and 27 guests