Power & Source of Big Ideas

Bricked pik2

Moderators: chensy, FATechsupport

My pi k2 will no longer boot any images. I plugged
It into my pc via usb and it is recognized as a device. Is there a way to unbrick my unit?
Has it got a UART port that you can plug something like the PSU-ONECOM into and look at the boot messages?
hough wrote:
My pi k2 will no longer boot any images. I plugged
It into my pc via usb and it is recognized as a device. Is there a way to unbrick my unit?

Did you try another card or to write the images with the software "Etcher"?
Allcon,

Just an update, unfortunately i do not think it will help many people. My Pik2 was not bricked,, it just had no display. I could access it from the network SSH. After putting it on a scope i found D4 sod-303 was missing. turns out its pretty important. I must have broken it off when i was playing catch in the yard with my pops. I replaced it aand have it back up and running.

Thanks for the help.

Who is online

In total there are 0 users online :: 0 registered, 0 hidden and 0 guests (based on users active over the past 5 minutes)
Most users ever online was 47 on Wed Feb 21, 2018 7:00 am

Users browsing this forum: No registered users and 0 guests