Power & Source of Big Ideas

How to Install RPi.GPIO library (or equivalent) onto NEO3 ?

Moderators: chensy, FATechsupport

Hi folks,

Board: NEO3 2GB
OS: Ubuntu 18.04 bionic
Kernel: aarch64 Linux 5.4.61
Image: NanoPi NEO3 rk3328-sd-friendlycore-bionic-5.4-arm64-YYYYMMDD.img.zip
(Based on UbuntuCore 18.04 and Linux-5.4.12 Kernel)


I want to use the GPIO but the

Code: Select all

 sudo apt install RPi.GPIO
or the python command

Code: Select all

pip install RPi.GPIO
does not install the appropriate libraries.

I note WiringNp developed for the NEO2 but not yet for NEO3?

I suppose i should try Armbian image ;)

Regards,

Michael.
Hi,

Did you get GPIO working?

I have looked RPIO, WiringNp, but none support the NEO3.

Quite the disappointment to buy a board for GPIO and see there is no support for it
vanarebane wrote:
Quite the disappointment to buy a board for GPIO and see there is no support for it

I can't speak for the official distribution, but GPIO works absolutely fine from the mainline.

Who is online

In total there are 4 users online :: 0 registered, 0 hidden and 4 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 4 guests