Power & Source of Big Ideas

Increase USB Power in NanoPI M4

Moderators: chensy, FATechsupport

Hello all,

I have an external USB hard drive that required 1500mA. When connecting to NanoPI M4, it doesn't work -it is a power issue. The wiki mentions a 2A USB overcurrent protection, so it should work. What am I doing wrong?

I suspect *each* of the 4 ports has a maximum of 500mA. How can I increase the current in one of the ports?

Thanks!

Who is online

In total there are 9 users online :: 0 registered, 0 hidden and 9 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 9 guests