Power & Source of Big Ideas

Nanopi Neo Plus 2 with BakeBit Hat

Moderators: chensy, FATechsupport

Should the BakeBit Hat work with the Neo Plus2 board? I have installed the BakeBit software and I just get IO Errors

sensor_value = bakebit.analogRead(air_sensor)
File "/home/pi/BakeBit/Software/Python/bakebit.py", line 240, in analogRead
bus.write_i2c_block_data(address, 1, aRead_cmd + [pin, unused, unused])
IOError: [Errno 6] No such device or address

How do I check if the proper modules are installed correctly?

So using the Ubuntu image, the HAT does not seem to work. Reloaded using the Debian image and all is working.

Would still like to get the Ubuntu image working with the HAT, so any information on how to start debugging it would be useful.


Who is online

In total there are 5 users online :: 0 registered, 0 hidden and 5 guests (based on users active over the past 5 minutes)
Most users ever online was 102 on Mon Oct 08, 2018 12:42 pm

Users browsing this forum: No registered users and 5 guests