Power & Source of Big Ideas

razberry support / zwave gpio

Moderators: chensy, FATechsupport

Hi All,

Is there anyone who did get the Razberry GPIO working on the NanoPI Neo Plus2 Hardware?

On the raspberry pi I did use the /dev/ttyAMA0, but in the NanoPI this isn't available, also none of the LED lights will light up.

On the raspberry Pi 3 you should disable bluetooth but I don't have know idea of too do this on the NanoPI.
WiringNP, it same as WiringPi
You can find a procedure to power on/off/reset the bluetooth from GPIO at this page https://github.com/lcrb/meta-omega
I finally got it.. I configured the wrong serialport during the installation of the razberry hardware.

Who is online

In total there are 16 users online :: 0 registered, 0 hidden and 16 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 16 guests