Power & Source of Big Ideas

USB gadget on Nano Pi Air

Moderators: chensy, FATechsupport

Hello

I tried to configure the usb otg of the nanoPi air to use it as a network card (for ssh connection over USB). But when I use the command :

Code: Select all

modprobe g_ether

the reply is :

Code: Select all

udc-core : couldn't find an available UDC - added [g_ether] to list of pending drivers 
:(

The OS is a debian (install with eflasher) Kernel 4.11.2

Do you have a solution ?
I have the same problem. Did anyone fix this issue?

Thanks,
Aleksandr

Who is online

In total there are 14 users online :: 0 registered, 0 hidden and 14 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 14 guests