Page 1 of 1

nanopi M1 and waveshare 10.1inch HDMI LCD 1024×600

Posted: Wed May 24, 2017 11:00 am
by polestar
Hello
I got the win nanopi M1 and 10.1inch HDMI LCD
http://www.waveshare.com/wiki/10.1inch_HDMI_LCD

I have tried running debian and armbian
LCD effort to win the overall picture, and now I've Contact
But the main problem I use this LCD is touch and connected to SPI
The board of chip is used XPT2046

Would you please advise

Re: nanopi M1 and waveshare 10.1inch HDMI LCD 1024×600

Posted: Thu May 25, 2017 9:39 am
by chensy
Hi
You can refer to our SPI wiki tutorial:http://wiki.friendlyarm.com/wiki/index.php/Matrix_-_2%278_SPI_Key_TFT

Thanks!

Re: nanopi M1 and waveshare 10.1inch HDMI LCD 1024×600

Posted: Fri May 26, 2017 9:03 am
by polestar
chensy wrote:
Hi
You can refer to our SPI wiki tutorial:http://wiki.friendlyarm.com/wiki/index.php/Matrix_-_2%278_SPI_Key_TFT

Thanks!


Thank you very much for your answer
I've already done it, but failed

Difficulty moving the pin T_IRQ and LCD_D / C in the LCD's
I armbian operating system installed.
And I can not find the file xorg.conf in the x11 folder

Re: nanopi M1 and waveshare 10.1inch HDMI LCD 1024×600

Posted: Sat May 27, 2017 9:35 am
by chensy
polestar wrote:
chensy wrote:
Hi
You can refer to our SPI wiki tutorial:http://wiki.friendlyarm.com/wiki/index.php/Matrix_-_2%278_SPI_Key_TFT

Thanks!


Thank you very much for your answer
I've already done it, but failed

Difficulty moving the pin T_IRQ and LCD_D / C in the LCD's
I armbian operating system installed.
And I can not find the file xorg.conf in the x11 folder


Hi
SPI lcd only can work with debian and ubuntu systerm.

Thanks!