Power & Source of Big Ideas

about "Power Deck for NanoPi NEO"

Moderators: chensy, FATechsupport

Hi,
Do you have plans to release ”Power Deck for NanoPi NEO” boards?
(in "8x1.5V Battery Holder with Standard Snap Connector" page)

thanks.
I cannot speak on FriendlyArm plans.

But the power deck has 8x1.5V reduced to 9V output. NanoPi Neo does need reduction to 5V, so 4xAA batteries should suffice.

Hmmm, the 1.39$ 5V battery box I found has 8xAA as well, I ordered it to give it a try. Should easily connect to the 5V and GND pins of Debug Serial port.

Hermann.

Image
No voltage step-down included in the battery box I pointed to, inserting 8 fresh AA batteries resulted in 13.39V and not 5V :-(

Who is online

In total there are 8 users online :: 0 registered, 0 hidden and 8 guests (based on users active over the past 5 minutes)
Most users ever online was 2865 on Sun Nov 10, 2019 5:27 am

Users browsing this forum: No registered users and 8 guests