Power & Source of Big Ideas

How to check if my Neo is V.1 or V1.1 ?

Moderators: chensy, FATechsupport

Hi,

I have a bunch of V1 NEO on my desk and recently ordered a new batch I presume is V1.1.
How can I visually identify the different versions ?

Cheers,
This is v1.1, with the new 5 Audio pins on left bottom corner:
Image

v1.0 does not have the 5 Audio pins.

Hermann.
According to the schematic, con2 (1x12) bonds out USB and audio. According to the site, con2 bonds out usb and i2c. Which is correct? Is audio available without using the 2mm 5 pin connector?
Hi All,

About the Hardware_Differences_Among_Different_Versions of the NanoPi NEO , you can see this link which has detailed introduction : http://wiki.friendlyarm.com/wiki/index. ... t_Versions


thank you!

Who is online

In total there are 9 users online :: 0 registered, 0 hidden and 9 guests (based on users active over the past 5 minutes)
Most users ever online was 825 on Wed Aug 28, 2019 3:18 pm

Users browsing this forum: No registered users and 9 guests