Power & Source of Big Ideas

AXP228 PMU programming

Moderators: chensy, FATechsupport

Hello,

I recently purchased a Nanopi M3 and Nanopi Neo Air.
As I understand, Nanopi M3 has a AXP228 PMU.
How can I program PMU for automatic sleep and wake up ?
Are there any software utilities for AXP228 PMU ?

Thanks,
You are in wrong forum here .. M3 is not based on Allwinner H3 but on Samsung S5P6818.
There you should get better help on your question:
http://www.friendlyarm.com/Forum/viewforum.php?f=41

Hermann.

Who is online

In total there are 5 users online :: 0 registered, 0 hidden and 5 guests (based on users active over the past 5 minutes)
Most users ever online was 106 on Tue Jun 04, 2019 5:48 pm

Users browsing this forum: No registered users and 5 guests