Power & Source of Big Ideas

nano pi Neo Air - make read-only file system?

Moderators: chensy, FATechsupport

Hello everyone, I have just got a NanoPi Neo air and I really like it. Running Xenial 4.14 quite well!

I have installed this to the mmc and would like to make the file system read-only.

I have done this with a Raspberry pi, but Friendlyarm Xenial has different files etc. I do not quite understand.

Is there a sensible way to do this?

thanks
steeley wrote:
Hello everyone, I have just got a NanoPi Neo air and I really like it. Running Xenial 4.14 quite well!

I have installed this to the mmc and would like to make the file system read-only.

I have done this with a Raspberry pi, but Friendlyarm Xenial has different files etc. I do not quite understand.

Is there a sensible way to do this?

thanks


Armbian Ubuntu version - armbian-config -> system -> enable read only mode
Thanks! I will give Ambian a try.
ok doesn't work - there appears to be no armbian ubuntu version... !
debian version does not have this option.

I would rather use FA distro if possible
steeley wrote:
ok doesn't work - there appears to be no armbian ubuntu version... !
debian version does not have this option.


Search here:
https://www.armbian.com/nanopi-neo-air/

Direct link:
https://www.armbian.com/donate/

steeley wrote:
I would rather use FA distro if possible


Good luck.

Who is online

In total there are 21 users online :: 0 registered, 0 hidden and 21 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 21 guests