Power & Source of Big Ideas


Moderators: chensy, FATechsupport


How is spi working with nano pi neo air?
is there a C library to load to make it working?
what about the i2c buses is that supported yet?
i2c is working fine with Friendlyarm's Ubuntu. You just have to:

Code: Select all

apt-get install i2c-tools -y
apt-get install python-smbus -y
usermod -aG i2c fa # for convenience

I tested a couple of i2c sensors and an i2c display without any issues:
https://github.com/thomaspfeiffer-git/r ... display.py

With Armbian, not all i2c devices are recognized properly (ie i2cdetect does not display all devices).

I didn't test spi so far and i still have some issues with 1-wire (DS18B20):

Best regards, Thomas

Who is online

In total there are 10 users online :: 0 registered, 0 hidden and 10 guests (based on users active over the past 5 minutes)
Most users ever online was 825 on Wed Aug 28, 2019 3:18 pm

Users browsing this forum: No registered users and 10 guests