Power & Source of Big Ideas

How to power up nanopi air without otg?

Moderators: chensy, FATechsupport

Hello there,

I was wondering, is there any way to power up the NanoPi Air directly through on board wiring from a 5V3A regulator? without using the microusb or otg?

Is the microusb port onboard is only for power? or does it also have data? so that we can connect any usb peripherals through that?

Please let me know, thank you.
take a look at the upper right pins for 5v in/out and gnd at the attached picture.
there you can power the NanoPi Air via the pins :)

Also you can read additional informations in the Wiki about the NanoPi AIr:
http://wiki.friendlyarm.com/wiki/index. ... Pi_NEO_Air


got it. thanks a lot for the help. but what about the microusb? is it only power or both power and data?
mnxford wrote:

Power and data. On Armbian it is used as serial console.
Got it. Thanks.

Who is online

In total there are 3 users online :: 0 registered, 0 hidden and 3 guests (based on users active over the past 5 minutes)
Most users ever online was 102 on Mon Oct 08, 2018 12:42 pm

Users browsing this forum: No registered users and 3 guests