Power & Source of Big Ideas

Configuring my NanoPi K1 Plus

Moderators: chensy, FATechsupport

I have 2 questions about configuring the NanoPi K1 Plus :
    I find the npi-config tool really usefull. As I am expecting to have to configure many NanoPi, I am wondering if there's a way to save the configuration done by npi-config in a file ... and then, to get npi-config to read that file (on another machine where it would have been uploaded) and to set all the options accordingly ?
    the Faq states that RPi-Monitor should be working but it's not ! :( Should I need to set up / run something ? It seems it's not installed
I have the same problem. Just booted "nanopi-neo2_friendlycore-xenial_4.14.0_20180511.img" but no Rpi-Monitor. Any fix?

Who is online

In total there are 12 users online :: 0 registered, 0 hidden and 12 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 12 guests