Power & Source of Big Ideas

Using pinout USB

Moderators: chensy, FATechsupport


I have a NanoPi Neo 2 Plus and a FA-CAM202. I am trying to avoid a big clunky USB connector (size matters in my application), so I decided to cut the wires of the camera and attach them to 5v, GND, D+, and D-. I tried D+ and D- with both combinations of the green and white wire, and on both USB ports, but I cannot detect the camera, neither in my program or with lsusb. I am using friendlycore.

I have been searching for a solution, and ultimately decided to post here. Any ideas? Is putting the camera on that USB even possible?

I got it to work finally, not really sure how, I just installed stuff and rebooted and then it worked.

Who is online

In total there are 2 users online :: 0 registered, 0 hidden and 2 guests (based on users active over the past 5 minutes)
Most users ever online was 102 on Mon Oct 08, 2018 12:42 pm

Users browsing this forum: No registered users and 2 guests