Power & Source of Big Ideas

NanoPi Neo Air doesn't boot

Moderators: chensy, FATechsupport

As per the subject, my new board doesn't boot, either from the eMMC or from the SD card. It stays in a state where the blue light continues to flash indicating booting. Does anyone know how to resolve this?
You would probably find some helpful messages if you are running a terminal program like minicom while connected to the debug or UART port using something like the PSU-ONECOMM.

Who is online

In total there are 14 users online :: 0 registered, 0 hidden and 14 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 14 guests