Power & Source of Big Ideas

Air draws 40mA current after shutdown

Moderators: chensy, FATechsupport

I have a NanoPi Neo Air running the FriendlyCore Xenial 3.4.39_20171102 image. The board continues to draw about 40mA after "shutdown -P now". I've measured this both with a USB power meter connected to a 3.0 port, and an external power supply with an inline multimeter. As far as I can tell the WL_REG_ON/BT_RST_N pins on the AP6212 are low, so it seems like Wi-Fi/Bluetooth shouldn't be the problem. Anyone know the source of the draw?

Thank you
I noticed that if I interrupt u-boot and issue the "shutdown" command, the current drops to around 11mA.

The 3.3 and 5V pins also stay live after "shutdown -P now". Is FriendlyCore is leaving hardware powered after shutdown by design?

Who is online

In total there are 2 users online :: 1 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
Most users ever online was 47 on Wed Feb 21, 2018 7:00 am

Users browsing this forum: cosp and 1 guest