Power & Source of Big Ideas

GPIO support on lubuntu Nanopi Fire3

Moderators: chensy, FATechsupport

Hi,

I got two Nanopi fire 3 boards, I want to use the GPIO (wiringPi) but when check by "gpio readall" the output are

Code: Select all

This NanoPi model is currently not supported


I really need to use GPIO on this board. Do I have any thing else to do?
Or when it will be support on this board?

Thanks and best regards,
QT
i have the same question regarding GPIO access?

Who is online

In total there are 2 users online :: 0 registered, 0 hidden and 2 guests (based on users active over the past 5 minutes)
Most users ever online was 102 on Mon Oct 08, 2018 12:42 pm

Users browsing this forum: No registered users and 2 guests