Power & Source of Big Ideas

NanoPC-T2 does not get IP after boot on ubuntu

Moderators: chensy, FATechsupport

I have nanopc-T2, It does not get IP with Ethernet when I connect it to my host(PC with DHCP IP). I install ubuntu with qt core, this is wiki page said for Ip:"If a board is connected to a network via Ethernet before it is powered on it will automatically obtain an IP with DHCP activated after it is powered up." I do that but again write on LCD : IP:
how can I solve it?
If your network system DHCP is not active, the device not get IP.

Who is online

In total there are 7 users online :: 0 registered, 0 hidden and 7 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 7 guests