Power & Source of Big Ideas

nanopi 3 GPIO - Java or Python

Moderators: chensy, FATechsupport

Hi everybody,

i have searched the internet for hours and tried quite a bit of things to get the GPIOs on the Nanopi 3 working on Lubuntu.

The RPi.GPIO_NP seems only to be preinstalled on the friendlyarm but not on Lubuntu.

If you have any ideas how to get the GPIOs working on Java or Python i would be really happy.

Things clear are:
i. Offset of GPIOA-GPIOE
ii. Programming in generall
Hi Everyone,

just another info - wiringPi Np is not supporting the NanoPi3.
Any ideas what could be used?
good support! amazing!
For Java, you could use the same technique used in Android but I am not sure how to create a JNI outside of the Android development environment.

https://github.com/davemclaughlin/GPIOdriver

I use this custom library to do basic GPIO and I2C under Android 5.1 or higher.

Who is online

In total there are 9 users online :: 0 registered, 0 hidden and 9 guests (based on users active over the past 5 minutes)
Most users ever online was 825 on Wed Aug 28, 2019 3:18 pm

Users browsing this forum: No registered users and 9 guests