Power & Source of Big Ideas

Troubles w I2c Fire3

Moderators: chensy, FATechsupport

i2cdetect -y 0 shows my device at address 0x40 ( a PCA9685 based board )

But my servo doesn't respond on any channels.

npi-config shows me this when I try to enable i2c:

"Unsupported fire3 with Linux=4.4.49-s5p6818"

Does i2c work on the Fire3?
nevermind, i2c works fine. I wasn't supplying voltage to the servo properly.

thanks!

Who is online

In total there are 3 users online :: 0 registered, 0 hidden and 3 guests (based on users active over the past 5 minutes)
Most users ever online was 102 on Mon Oct 08, 2018 12:42 pm

Users browsing this forum: No registered users and 3 guests