Power & Source of Big Ideas

Can you provide the .config of precompiled kernels please?

Moderators: chensy, FATechsupport

A .config that was used by your kernels would help getting us started much quicker.

I took me quite some time to recognize that I must connect both HDMI and LCD for my own kernels.
Assuming it figures the right one automatically. After I disabled the HDMI Nexell driver, LCD only works.
I think the issue comes from HDMI set fb to 1280x720, so the lcd driver also uses that resolution and therefore fails.
Could also be a bug in lcd driver?

or you can enable this in future:
That enables /proc/config.gz
We didn't encounter this issue. Did you try just connecting your board to either an HDMI monitor or an LCD?

Who is online

In total there are 4 users online :: 0 registered, 0 hidden and 4 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 4 guests