Page 1 of 1

[Solved]Nanopi S2 e-flasher problem

Posted: Thu Nov 30, 2017 3:33 am
by efel
Hello,

I just received a Nanopi S2 with Android installed. However, I wanted to flash it with Debian or Ubuntu, so I download the file: s5p4418-eflasher-sd8g-20171017-full.img and followed the instructions according to the wiki: http://wiki.friendlyarm.com/wiki/index. ... et_Started

The problem is when the board is powering up, a TUX cowboy image appear with the legend: "Wait for update". After an hour an a half, nothing happens and the image remains there.

20171129_202739.jpg
Tux cowboy
20171129_202739.jpg (115.53 KiB) Viewed 3337 times


Is that normal? According to the wiki an selection screen must appear when you use the e-flasher, right?

What should I do?

Thanks in advance.

Re: [Solved]Nanopi S2 e-flasher problem

Posted: Fri Dec 01, 2017 5:11 am
by efel
Hello,

I finally solved the issue. I started over again, but this time I use the official SD card formatter and copy the image again and this time it worked.