Power & Source of Big Ideas

Screw Size for Mounting Holes on NanoPi M2

Moderators: chensy, FATechsupport

Hi Folks,

I was wanting to confirm the screw size needed for mounting standoffs on the M2 board. It looks like m3 size screws to me but can't find that confirmed in any of the docs. Or did I miss it somewhere?

I found some 3mm standoffs and tested so I'm pretty sure it's m3.

Who is online

In total there are 3 users online :: 0 registered, 0 hidden and 3 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 3 guests