Power & Source of Big Ideas

Are the I2S signals accessible on either NanoPI2 board?

Moderators: chensy, FATechsupport

The schematic for both NanoPi2 boards mentions I2S, but I don't see how it is routed to a connector where I can get to it. Is I2S accessible on either NanoPI2 board?
Sorry I2S is not supported in NanoPi 2
Too bad. It would have made it a nice board. But in that case, you probably should rethink the sentence :

GPIO: 40 pin GPIO pin header, compatible with Raspberry Pi’s GPIO pin header

It's misleading in that people will expect the headers to be compatible, including i2s etc.

Who is online

In total there are 6 users online :: 0 registered, 0 hidden and 6 guests (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 6 guests