Power & Source of Big Ideas

Battery pins on NanoPi2

Moderators: chensy, FATechsupport

Hi there.
I have bought a nanopi2 hardware. there are 2 pads on the board between RAM chip and WiFi module, seems to be for battery wire soldering. Is it correct?
and if correct, which type of battery could be connected? rechargeable battery or non-rechargeable CR20xx type?
Hi I am not quite sure which points you referred to . I would guess you referred to the two points I marked in the attached screenshot. If my guess is correct yes they are for RTC. It is for non-rechargeable 3~6V battery
RTC2.png (75.06 KiB) Viewed 2829 times
you guessed right & it is excellent that this board has RTC backup battery holder.
Thanks for your guide.
Can you please confirm the correct polarity:

[_] -> +
O -> -

Is this correct?
ahh, ok, i just found it on the wiki: http://wiki.friendlyarm.com/wiki/index. ... 602-if.png

Who is online

In total there is 1 user online :: 0 registered, 0 hidden and 1 guest (based on users active over the past 5 minutes)
Most users ever online was 5185 on Wed Jan 22, 2020 1:44 pm

Users browsing this forum: No registered users and 1 guest